9" x 12" Edge Mount Trim Tab Kit without Switch Kit -12V Lenco Electric Edge Mount Trim Tab Kits make your boat ride smoother, dryer, faster and with increased safety whether on a small skiff or a large yacht. The Lenco ball screw design is more reliable, three times more powerful and features an instant response, which makes them very user friendly compared to typical hydraulics. Lenco fast response electric actuators are fully submersible with all plug & play waterproof Deutsch connections. Edge Mount actuators mount at the trailing edge of the plane, requiring 4" (10.16 cm) less transom height than Lenco standard mount trim tabs.Kit Contents:2 each of 12-gauge stainless steel trim tab blades2 each of #15054-001 actuator with 6' leads & Deutsch plugs2 each of #30133-103 20' actuator extension wiring harnesses2 each of #15085-001 (116) upper mounting brackets with gland seal2 each of #50014-001 (119) lower mounting brackets1 each of the Lenco owner’s / installation manualAll necessary stainless steel mounting hardwareSpecifications:Suggested Boat Length: 16' to 25'Length of Tab: 9"Width of Tab: 12"Hinge Height: 2"Minimum Transom Height: 13.5"Blades: 12 Gauge Stainless SteelFinish: SmoothSwitch Kit: Sold SeparatelyClass: Fuel EfficientCompliance: CE CertifiedCompatibility: Any BoatActuators: 12-voltWARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.