GBC012 Boost OBD-II Settings KeeperThe GBC012 OBD-II 12V Boost Settings Keeper allows you to disconnect your vehicle's battery without losing onboard electronic settings, such as radio and clock settings, seat positions, alarms, GPS, keyless entry codes and more. It's simple to use. Just connect the OBD-II 12V Boost Settings Keeper to the XGC 12-Volt Out Port on a GB70 or GB150 Ultra Safe Lithium Jump Starter and power on the jump starter. It features a Type-A OBD-II 16-Pin diagnostic connector for vehicles with a 12-volt supply voltage per SAE J1962 specification. Features:DANGER: NEVER START A VEHICLE OR CHARGE THE VEHICLE’S BATTERY WHILE CONNECTED. WHEN USED IMPROPERLY AND/OR AGAINST RECOMMENDED USE, IT MAY RESULT IN PROPERTY DAMAGE, SERIOUS INJURY, OR DEATH. Always turn off as many electrical loads as possible before using. (ie. Headlights, AC, Radio, etc.)WARNING: This product is fused at 10 Amps. Always check with the vehicle manufacturer to verify the maximum current supported through the OBDII port. Do not use if the vehicle’s OBDII fuse is below 10A and/or shares a fuse with the ECU or other sensitive equipmentMaintains onboard vehicle computer systems; perfect when disconnecting the battery or making battery changesWorks through the XGC OUT port on NOCO GB70 and GB150 Jump StartersCompatible with any OBDII port (All vehicles built after 1995)Maintains voltage continuity to vehicle onboard computer; retains clock, radio, and seat memoryCompatible with the NOCO Genius GB70 & GB150 Boost Jump StartersKeep on-board computer information while you change your batteryChange your battery, not your settingsConnect the Boost Settings Keeper while replacing your batteryIn-line replaceable fuse offers an additional layer of safetyWARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.